Installation guide

➢ Menu 2 - Convenience

2-1 One time bypass Off (1):

One time bypass ON. When programmed On

(2) the unit does not passively arm/lock for one cycle when turning the ignition

On and Off within 3 seconds. When going through this procedure the siren

chirps once indicating that One Time Bypass has been activated.

2-2 Nuisance Prevention® Circuitry (NPC) On (1): Nuisance Prevention Circu-

ity OFF (2). NPC stops repeated triggering of the same zone. If one zone is

triggered three times in one hour, that zone is bypassed for one hour, starting

from the time of the third trigger. During that hour, if the system sees a trigger on

that zone again, the system resets the one hour timer.

If one hour passes and the zone has not triggered again, the zone is activated

and can trigger the system again. NPC only monitors sensor inputs, and does

not bypass the door trigger or the ignition trigger at any time.

If NPC is turned off, the system responds to repeated triggers on the sensor

inputs and will do so indeﬁnitely. Some states have laws regulating how many

times a security system can trigger before it is considered a nuisance and the

vehicle is towed away.

2-3 Disarm from Valet, 1 pulse (1)

. Disarm from valet, 2-5 pulses (2). The system

can be programmed to count the number of presses of the valet switch before

disarming the security system. The factory default setting is one pulse. The unit

can also be set for two to ﬁve pulses.

2-4 Door trigger error chirp On (1):

Door trigger error chirp Off (2). This feature

controls the error chirp that is generated if the system is locked with the door

trigger active. This is useful in vehicles with a long dome light delay after the

door is closed. If the system is locked before the dome light turns Off, the system

generates the door trigger error chirp. If this error chirp notiﬁcation is not desired,

use this feature to disable the door open error chirp notiﬁcation. If the error chirp

notiﬁcation is turned Off, no bypass chirp is generated, even if a door is ac-

cidentally left open.

2-5 Ignition Controlled Dome Light Supervision On (1):

If turned on, the system

turns on the dome light for 60 seconds when the ignition is turned off. The op-