Installation guide
40
© 2008 Directed Electronics. All rights reserved.
Note:
Some features have more than two possible settings. Pressing
A U X
or
A U X
toggles through the two-chirp and higher settings.
Once a feature is programmed:
Other features can be programmed within the same menu•
Another menu can be selected•
The learn routine can be exited if programming is complete•
To access another feature in the same menu:
Press and release the Valet/Program switch the number of times necessary 1.
to advance from the feature you just programmed to the next one you want
to program.
Then press the Valet/Program switch once more and hold it. 2.
For example, if you just programmed the third feature in the menu and you want
to program the seventh feature in the menu, press and release the Valet/Program
switch four times and then press it once more and hold it. The siren chirps seven
times to confirm access to the seventh feature.
To select another menu:
Press and hold the Valet/Program switch.1.
After three seconds, the unit advances to the next menu and the siren 2.
chirps, indicating which menu has been accessed.
If you just programmed features in the first menu and you want to program a
feature in the third menu, press and hold the Valet/Program switch. After three
seconds the siren chirps twice indicating access to the second menu. Continue
to hold the button and three seconds later the siren chirps three times indicating
access to the third menu.
Features in the third menu are then programmable following steps 4 through 6
of the System Features Learn Routine procedure.
The learn routine exits if any of the following occurs:
The open door is closed•
The ignition is turned On•
There is no activity for 30 seconds•
The Valet/Program switch is pressed too many times•