User`s manual

SYSTEM CONTROLLER User’s Manual
31
SYSTEM CONTROLLER User’s Manual
30
DVR Mode
Controller Mode
Press the SETUP button on the initial screen to display the
[SETUP SYSTEM] menu.
Press the 2 button to activate the [DVR SETUP] menu.
Press the 1 button to activate the [DVR Model SETUP] menu.
Press a number on the number pad to set the DVR ID.
The DVR model name saved in EEPROM will be
displayed on the LCD monitor when changing DVR ID.
Press the + and - buttons to change the DVR model name.
Press the ENTER button to finish the setup.
DVR MODEL Setup
This menu is for setting the DVR ID and model for
operation by a controller. Sub-controllers cannot be
used if the master controller is in Setup mode.
Press the SETUP button on the initial screen to display the
[SETUP SYSTEM] menu.
Press the 3 button to activate the [CONTROLLER
SETUP 1
] menu.
Press the button to activate the [ CONTROLLER
SETUP 2
] menu.
Press the button to activate the [
CONTROLLER SETUP 3] menu.
At the [CONTROLLER SETUP 1 ], [ CONTROLLER
SETUP 2
] or [ CONTROLLER SETUP 3] menu, press a menu number to open a setup
menu.
1. Setup Mode
• Press the ESC button to move to the upper setup mode.
• The Controller Setup menu can be added to enhance controller functionality.
Reference
Contents
• When connecting to an SVR-1650/1640/950, the SYSTEM ID must set equal to the Controller
DVR ID (Menu Network RS422/485 SYSTEM ID).
• When connecting the SVR-1650/1640/950 to the controller, use Port A on the left of RS422/485
located on the back side. Port B is for SPEED DOME connection. For RS485 connection, press the
TERM switches 1 & 2 down to the ON position (located next to the RS422/485 PORT).
It unifies the model of the SVR-1650/1640/950/440 with the SVR-1650.
• When connecting to an SVR-1630, the SVR-1630 keyboard control address must be set to be the
same as the controller DVR ID (Menu System Setup Misc.).
• For the SVR-1630 COM2 RS422/485 menu (Menu System Setup Serial Port), Device must be set
to SCC-3000 and Interface to RS-485, and for the COM4 RS422/485 menu (Menu System Setup
Serial Port), Device must be set to SPD2500 (if an SPD2500 is connected) and Interface to RS-485.
• When controlling a PTZ camera via an SVR-1630, connect the SVR-1630 and the controller to
COM2 RX+/RXand connect the SVR-1630 and PTZ camera to COM4 RX+/RX-. Also, at the SVR-
1630 channel setup menu, set the PTZ port of each channel to COM4 and set the PTZ address to
be the same as the PTZ camera ID.
• When connecting to an SVR-430, the SVR-430 system ID must be set to be the same as the
controller DVR ID (Menu Network/Communication RS422/485 SYSTEM ID).
Model
SVR-1650/1640/950
SVR-1630
SVR-430
Contents
• To connect to the SVR-5416/5116: System Remote Controller setup Serial (RS232/RS485)
check on Serial setup Communication Port 1/Equipment Number setup (Port setting must
be identical to controller’s communication settings. Default (9600, 8, N, 1))
Model
SVR-5416/5116
When entering '1'
ENGLISH