User`s manual

SYSTEM CONTROLLERSYSTEM CONTROLLER User’s ManualUser’s Manual
2120
ENGLISH
1. PTZ Setup Mode
This menu is for setting up the PTZ camera function. It is impossible to operate Speed
Dome and DVR by sub-controllers when the master controller is set to on.
Press the SETUP button on the initial screen to display
the [SETUP SYSTEM] menu.
Press the 1 button to activate the [PTZ SETUP 1 ]
menu.
Press the button to activate the [ PTZ SETUP
2] menu.
At the [PTZ SETUP 1 ] menu, press the 1 button
(see p.21).
Use the joystick or camera control button (SCC-3100
model) to move the camera to the desired location
(move up, down, left, and right, and control zoom).
Enter a preset number.
Press the Enter button to assign the number to the
current location.
2. PRESET
This menu is for setting the camera to move to preset locations.
The menu may be different depending on the PTZ camera model.
• Press the ESC button to move to an upper setup mode.
Reference
Menu Models supported Menu Models supported
PRESET
SPD series, PELCO-D/P, PANASONIC,
MODEL
SPD series, PELCO-D/P, PANASONIC,
SAMSUNG ELECTRONICS, ELMO, BOSCH SAMSUNG ELECTRONICS, ELMO, BOSCH
SWING SPD series TRACE
SPD series, PELCO-D/P,
PANASONIC
GROUP SPD series AF
SPD series, PELCO-D, PANASONIC,
SAMSUNG ELECTRONICS
TOUR SPD series - -
2-1. PRESET Setup
In the initial screen, enter an assigned preset number.
The selected number will be shown in the [- - -] display.
Press the Preset button to move the camera to the preset location.
If the number entered is not within the selectable range, the last entered number is
taken as the first number.
PRESET select range: 1~255
PRESET 255 may not be supported depending on the type of camera. (See the camera
manual for more information.)
Preset setup is also available in the OSD menu of the connected camera.
2-2. PRESET Movement
PTZ Mode PTZ Mode
ENGLISH