- Clifford Remote Start Keyless Entry Owner's Guide

32
© 2008 Directed Electronics. All rights reserved.
➤ Menu option descriptions
Auto keypad lock•
Automatically locks the remote buttons when the buttons are not used for
60 seconds. Prevents “accidental” presses of the remote.
Press
A U X
then
A U X
to unlock the keypad.
Note: If the auto keypad lock feature is programmed On, the remote un-
locks when the vehicle ignition is turned Off. The remote stays unlocked to
allow time to exit and unload the vehicle, and then lock the doors with the
remote. When the
A U X
button is pressed, the keypad auto lock feature
resumes normally.
Page On or Off and Power save•
When paging is “On” the remote checks the status of the system every four
seconds, and reports any factory alarm triggers (if the system is within the
operating range and the factory alarm option is installed).
In the paging “Off” setting, the remote does not check the status of the
system. In the paging Off mode the remote beeps when a button on the
remote is pressed.
In the “battery saver” mode, the remote goes into sleep mode if no buttons
are pushed for 72 hours. The timer resets each time a button is pressed.
Page Alert /Vibe/Beep Tone/Both or /Screen only•
Receive command confirmations on the remote with vibrations, beeps or
both, or with display only.
Remote start display: Clock, temperature and runtime•
Allows you to choose what is displayed in the text during the remote start
sequence. Clock displays the current time during remote start.
Temperature displays the current cabin temperature during the remote start.
Runtime displays the runtime remaining during the remote start.