- Clifford Remote Start Keyless Entry Owner's Guide

17
© 2008 Directed Electronics. All rights reserved.
Points to remember :
If the hood is open or if the brake pedal is pressed, the vehicle will not remote
start. The remote start shuts down:
When the brake pedal is pressed.•
The hood is opened.•
When the remote start command is sent again from a remote control.•
When the runtime expires.•
To drive your vehicle after it has been remote started:
Get in without stepping on the brake. 1.
Insert the ignition key and turn it to the ON position.2.
Now, step on the brake. 3.
The remote control will play the remote start shutdown tone. You have now
taken direct control from the remote start system.
Valet Take-Over
The Valet Take-Over feature allows the vehicle to remain running after the key
has been removed from the ignition. This feature is useful for occasions when
you wish to exit and lock the vehicle for short periods of time, but would like to
leave the motor running and the climate controls on.
To enable Valet take-over; while the vehicle is running, press
A U X
1 time and the
parking lights will flash after a couple of seconds turn off the ignition and the
car should stay running. Once you exit the vehicle you can lock the system and
the car will remain running. If the vehicle shuts down, then the unit did not enter
valet take-over mode.