Installation guide

10
© 2011 Directed Electronics. All rights reserved.
Remote Pairing
Prepare the vehicle system to be Paired with a new remote
1. Open a door.
2. Turn the key to the ON position.
3. Within 5 seconds press and release the Control button on the Control Center one time.
4. Within 5 seconds, press and hold the Control button on the Control Center. The status LED will flash one
time and the siren then chirps to confirm the vehicle is ready for remote pairing.
5. Release the Control button and proceed below.
Note: If no remote pairing results, the system will exit after 60 seconds.
Prepare the Responder HD 2-way remote control to be Paired with the system:
Remote Pair matches your HD remote to the system. Make sure the HD remote is set for the desired Car 1
(Default) or Car 2 operation for the system it will be paired with.
1. With the HD remote control display blank, press in and hold the menu wheel for 3 seconds until
Settings
screen appears.
2. Toggle the menu wheel until
Adjustments
screen appears
3. Press in on the menu wheel to enter.
4. In the
Adjustments
menu highlight
Remote Pair
and press in the Menu Wheel to go to the Remote Pair
screen. Follow the on screen instructions:
I. Press and hold the
AUX
button until tones are played.
II. The system chirps the siren to indicate it has learned the HD remote ID and is sending its ID to the
remote.
III. Release
AUX
button.
5. Successful or Failed Pair: The HD remote control indicates a successful or failed pairing on the display.
After a successful pairing, it then returns to the
Adjustments
menu. If pairing fails, it returns to the
Remote Pair
screen, press the
AUX
button to attempt another pairing.
Prepare the vehicle system to be Paired with the companion or a new 1-way remote as described above.
Note: If no remote pairing results, the system will exit after 60 seconds.
Prepare the companion 1-way remote control to be Paired with the system:
Make sure the remote is set for the desired Car 1 (Default) or Car 2 operation for the system it will be paired
with.
1. Press and hold the
AUX
button for 8 seconds.
Note: If Car 2 mode is on, ignore the Car Select beep after 3 seconds.
2. Wait for the Transmit LED to light solid and the remote to beep. Release the
AUX
button.
3. Press the
AUX
button for 1 second. The transmit LED will blink 3 times and beep 3 times.
4. Within 5 seconds, press the
AUX
button.
5. The vehicle siren will chirp. You have now successfully learned the remote to the vehicle remote start and
security system.
6. Press the
AUX
button two times to exit learn routine on the remote. The transmit LED will turn off and exit
tone will sound.