Manual

23
© 2008 Directed Electronics. All rights reserved.
➤ Runtime check
Your system has a feature (if programmed on) that automatically notifies you
when the run time is getting low. The default runtime is 12 minutes.
To check the amount of runtime remaining:
After the vehicle is remote started, press the button three-times and then hold
until the remote beeps, and then release. The LEDs light up to indicate how much
time is remaining.
100% runtime remaining
75% runtime remaining
50% runtime remaining
25% runtime remaining
When the remote
start and Function
LEDs are blinking,
there is less than
three minutes of
runtime left.