Manual

22
© 2008 Directed Electronics. All rights reserved.
Using the remote start
Read this user guide, including the warnings on page 6, before using the remote
start. Ensure that the vehicle is parked in an open area, not in a garage. To
use your remote start to pre-warm or pre-cool your vehicle, remember to set the
climate controls to the desired settings before shutting Off the engine.
➤ Remote starting your vehicle
Press the •
A U X
button on the remote control. The vehicle parking
lights flash.
On the 2-way remote, the Remote Start LED flashes and ascending Remote •
Start tone plays.
The preset remote start run time is 12 minutes. This can be changed to between
12 and 60 minutes (see your authorized dealer for programming changes).
Your system has a feature, if programmed On, that automatically notifies you
when the runtime is getting low. When the vehicle reaches 3-minutes of runtime
remaining, it sends the 2-way remote control a paging signal. The 2-way beeps
one-time, plays the error beep tone one-time, and then the
A U X
and LEDs
flash.
Points to remember
If the hood is open or if the brake pedal is pressed, the vehicle will not remote
start. The remote start shuts down:
When the brake pedal is pressed•
The hood is opened•
When the remote start command is sent again from a remote control•
When runtime expires•