Specifications

Quintech Electronics and Communications Inc.
SRX Series Switching System Rev. A
2
2.0 MODULES
Two types of modules are used to configure an SRX system: an MCP 128 (8x1) controller and a
16x1 switching module. Every SRX system is comprised of one controller and 1 or more
switching modules. A minimal SRX switching system consists of a single controller and one
switching module.
The MCP 128 controller provides master control capability via the front panel keypad/LCD
display or computer interface (serial or TCP/IP). The unit receives commands from the keypad
or computer and controls the individual switching modules. From this unit, an operator can
make routing changes or check to see the paths currently configured.
ETHERNET
INPUTS
OUTPUT
-5V
+5V
12
3
4
5
F1 F2
F3
F4
67890
Q-SWITCH
MCP 2150 SERIES
SIGNAL ROUTING SWITCH
C
O
N
T
R
O
L
O
U
T
C
O
N
T
R
O
L
I
N
12345678
MCP 128 (8x1) Controller
If no 16x1 switching modules are added to the SRX system, the controller can be used as a
standalone 8x1 switching module.
The SRX Switching Module is a 16x1 unit that utilizes solid state switching elements to provide
seamless switching speeds (nanoseconds). Up to eight switching modules may be combined in a
single SRX system. The total number of switching modules required for a system is equal to
the total number of system inputs divided by 16. Every switching module is equipped with two
inter-module serial ports (“CONTROL-IN” and “CONTROL-OUT”) that are used for
communication with other SRX modules.