Specifications

Quintech Electronics and Communications Inc. Protocol Version 2.15 8
SRX Series Protocol
DESIGNS AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE  2002 QUINTECH INC. ALL RIGHTS RESERVED.
ELE: Ethernet Lock Enable
This command enables the Ethernet command lock. When the lock is enabled, command
packets input from the Ethernet port are received but ignored except for the ELD command.
The ELD command is used to disable the lock and enable the processing of command
packets.
Command format:
02 XX XX 45 4C 45 03 XX
STX ADR ADR E L E ETX CHK
Example Command:
02 46 46 45 4C 45 03 4D
STX F F E L E ETX CHK
(Enable Ethernet Command Lock)
Positive response:
06 46 46 45 4C 03 0C
ACK F F E L ETX CHK
Note:
The switch is shipped from the factory with the Ethernet lock disabled so it will accept and process
command packets. If the ELE command is never issued, the Ethernet lock will never be enabled and
the ELD, ELE, and ELP commands can be ignored.
If the Ethernet lock is on, valid command packets sent over the Ethernet will return a NAK message
with the issued command, indicating that it was rejected because of the lock. Valid packets sent over
the serial port will still be accepted.