Specifications
Quintech Electronics and Communications Inc. Protocol Version 2.15 1
SRX Series Protocol
DESIGNS AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE ļ 2002 QUINTECH INC. ALL RIGHTS RESERVED.
Quintech SRX Series Protocol v2.15
8/18/2003 Rev A
This document specifies a common command protocol that can be used to control a Quintech
SRX controller from a computer.
Command Summary
This list gives the commands defined in Protocol 2.15.
C Check Change Flag / Unit Status. This flag will be set if a crosspoint has been changed
since the last polling or if any alarms are present.
E Ethernet. Various commands to set Ethernet parameters and control access.
F Firmware version. Identifies the SRX model, protocol and firmware version, and size as
set on the controller.
L Lock a crosspoint (or the front panel controls
1
).
O Output query. Queries for the input connected to the specified output.
Q Check queue. The queue stores up to 8 local changes made since the last āCā check.
S Set a crosspoint. Connect an input to an output.
U Unlock a crosspoint (or the front panel keypad
1
).
Other commands are reserved for future use.
1
This feature not available on standard 2.15 protocol systems.