Specifications

Quintech Electronics and Communications Inc.
SRX Series Switching System Rev. A
15
Password
The Password Screen enables you to reset the QEC port access password to the Quintech-
specified default. Press F4 to exit or F1 to reset the password.
Reset password F1=Enter
to “Quintech” F4=Exit
Password Screen
4.3 Ethernet Control
The SRX has a 10BaseT Ethernet port and supports TCP/IP. All commands are sent to the
configured IP address and port. The command protocol for controlling the switch is provided in
Appendix A
The same command protocol is used for control over the Ethernet QEC port and the serial port.
Since the same command formats are used, the command packet will contain a serial address.
This address must match the serial address of the SRX or the packet will be rejected, even
though the address is unnecessary when the command is sent over TCP/IP. To avoid any
problems, commands are sent over TCP/IP should use the broadcast address “FF” hexadecimal.
Please note that SNMP is not currently implemented.
Connecting the SRX via Telnet opens a Telnet console window. From the console window,
you can change the configuration or issue commands. The commands issued through the Telnet
window do not use a serial address or STX/ETX packet formatting.