Setup guide
68
www.SecurityCamerasDirect.com
SECTION 8: DVR SYSTEM MENUS REFERENCE
IP ADDRESS: Press ENTER, then enter the IP address.
SUBNET MASK: Press ENTER, then enter the subnet mask.
GATEWAY: Press ENTER, then enter the gateway address.
PPPOE network settings
When selecting PPPOE, enter the PPPOE USER and PASSWORD provided by your ISP.
MEDIA PORT: Port for private protocol between the DVR and a client PC. The default is 9000. If this port is used by the
computer for other communications, change the default value to an unused port.
WEB PORT: Sets up the port for the IE browser via HTTP. If this port number is changed, append the port number to the
IP address when connecting to PC to the DVR. For example, the WEB port is changed to 8088 and the DVR IP address is
192.168.15.145, the URL for the DVR (across the same subnet) is http://192.168.15.145:8088.
SETUP PORT: This port is xed and cannot be changed. It is set to 8000.
MAC ADDRESS: The hardware address of the network interface circuitry. This address xed and cannot be changed.
PPPOE user and password: Enter the PPPOE username and password provided by your internet service. Click the “check”
button in the lower right corner of the window to reboot the DVR. After rebooting, the device will save it and set PPPOE as
default network type. The IP address will be congured as a dynamic IP address.
DHCP network settings
When selecting DHCP, the DHCP server will assign the DVR IP address and other network settings. When you select DHCP and save
your conguration, the DVR will connect to the DHCP server and acquire its network settings.