Setup guide

31
4-Camera H.264 Security System Setup Guide
SECTION 5: NETWORKING YOUR DVR
d. Examine the screen capture shown above. If the response to the ping command was “Request timed out.” like
that shown above, use this IP address for your DVR, enter into Table 1, skip steps 2.e and continue at step 2.f.
If the response to the ping command was “
Reply from 192.168.1.100: ..” as shown below, a device exists on the
network that is using this IP address. If so, continue at step 2.e.
e. Since the response to ping test returned a reply as shown above, try the ping with another number between 1 and
255 until one is found that responds with the “R
equest timed out.” message. Use this IP address with your DVR and
enter it into Table 1.
f. In table 1, copy the PC’s Subnet Mask and Default Gateway entries into the DVR’s Subnet Mask and Default
Gateway cells.
3. At your DVR, click the System Settings icon on the Tool Bar to open the SYSTEM tab window.
System Settings