Setup guide
23
4-Camera H.264 Security System Setup Guide
SECTION 4: DVR SETUP
Privacy
Blocks
After the block is created, it can be repositioned by dragging it with a mouse.
To remove a block, double click on it.
4. Right click anywhere on the desktop to return to the VIDEO SETUP menu.
5. Click the conrm icon (a) in the lower right corner of the screen, then click the Conrm button in the Note window.
6. Repeat this procedure for the other camera channels, if necessary.
4.5 Network conguration settings
Use the NETWORK menu to congure your DVR for use on a LAN, for access through the Internet, for access from a smartphone, and
for issuing automated email when alarm conditions occur.
Refer to the Chapter 4, Networking your DVR for conguring your system for local LAN and Internet access. For other network
settings, including DDNS, EMAIL, MOBILE, and OTHER SETTINGS, refer to the chapter DVR System Menus.
NOTE
The default IP addresses and port settings of your DVR may be dierent from those shown in this document. Always use
network settings that are compatible with your network(s).
4.6 Alarm conguration settings
Use the ALARM menu to congure your DVR for behavior when the hard disk drive becomes full, and for motion detection
sensitivity of each channel.
1. Click the Settings icon on the Tool Bar to open the SYSTEM tab window.