Instructions / Assembly

58
59
Insert Hopper Assembly II(61) into Hopper Assembly I(3), align the holes as shown in
FIG 5. Insert the 5 32 32 6 Bolts(58) through the holes in the Hopper and / -
Hexagon Kep Nuts(59), then open the Hopper Lid and tighten it from inside. The four
sides are installed in the same way.
/ - * mm 5 32 32
1) Remove the Gaskets and Bolts from the Hopper, open the Lid, insert the Hopper into
the Chamber, then using Bolts and Gaskets install it in sequence from inside.
2.Assembling of Hopper
3.Mounting the Hopper to the Chamber
5
6
8
4.
Attaching the Hopper Handle to Hopper Lid
Using 5/32-32*5mm S/S Bolt(54) through 42* 12 10 Gasket(53), and install
Hopper Handle to Hopper lid. As Shown. Using Screwdriver to tighten them.
Φ . Φ * . mm
9
5.
Installing the Chamber Handle to Lid
1) Attach 1/4-20*12mm Bolt(48) through Φ6.5*Φ18*Φ2.0mm Gasket(50), installing
Handle (12) to Lid(9).
2) Using Wrench(55) to tighten them. (Do not over tighten these Bolts).
10
9
8
3
61
2) Locate the RTD plug-in connector coming from the mounted RTD inside the grill frame.
Connect this with the mating connector located on the outside of the hopper burner assembly.
7
LOCATE THE PLUG
FOR RTD AND PLUG
INTO MATING PLUG
FROM HOPPER
Washer
Bolt