Instructions / Assembly

Lid Assembly:

1.)Using a screwdriver to remove the screws and gaskets that have been

assembled in the Chamber.

2).Using the screws and gaskets to assemble the Lid as shown in the original position.

Adjust the Lid in the middle position of the Chamber and tighten the screws.

Mounting the Body Frame to the Chamber

1.)With the help of another person, put the Chamber on carboard, then attach 2 Left

Legs(38) to Chamber(1) with1/4-20*12mm Bolt(46), Φ6.5*Φ10*1.2mm Spring Washer

(60) and Φ6.5*Φ10*1.0mm Gasket(57). As shown in Figure1. Caution: The grill is very

heavy. Always lif

t the grill with 2

people. ( Do not over tighten the Bolts.)

2).Attach Right Rear Leg(41) and Right Front leg(42) on the Chamber(1) by using

1/4-

20*12mm Bolt(46) through Φ6.5*Φ10*1.2mm Spring Washer(60) and

Φ6.5*Φ10*1.0mm Gasket(57). As shown in Figure1.(Do not over tighten the Bolts.)

3).Attaching bottom plate(37) on 4pcs legs by using 1/4-20*12mm Bolts(46), keep it

steady. As shown in Figure 2.

4).Attach Axle(44) go through the holes of Right Rear Leg(41) and Right Front Leg(42).

Attaching 13 25 2 Gaskets(56) for right side and left side, then assembly

respectively Wheels(43), 85 25 2 Gaskets(47), Spring Washers(45) and Gap

Nuts(51), after that using wrench to tighten them. As shown in Figure 3.

Φ *Φ * mm

Φ . *Φ * mm