Instructions / Assembly

cleaning brush to give the Porcelain-coated Grill Grates a quick brushing when
you finish the barbecue. It takes only a minute and it will be ready the next time
you want to use the grill.
Clean the inner temperature probe after each time use.
Ash
Clean the ash from the interior of the grill periodically, otherwise excess ash
in the firepot may cause your fire to go out, especially in the SMOKE setting.
A shop vac is an excellent tool to handle the ash. (WARNING: Make sure you
grill is cold when you want to clean the ash from the grill.)
CAUTION: Make sure the grill is completely cool and unplugged before you do any
inspection, cleaning, maintenance or service work.
Problem
Potential
Cause
Solution
Grill does not work
properly
Power
Make sure the power cord is plugged in.
Verify there is power at the electrical
outlet.
Fuse
Hot Rod
Control Board
Auger Drive
Motor
Remove the control, check the fuse on
back. Replace the fuse if blown.
If both of the Draft Inducer Fanand the
Auger Driver Motor are operating, the
Hot Rod needs to be replaced. If one or
both are not operating, please contact
us.
Remove the Control Board, check the
wires and connections. Feel free to
contact us if you need help.
Locate the small fan blade on the back
of the auger drive motor, turn unit on, if
the fan does not turn, it indicates the
Auger Drive Motor need to be replaced.
Fire goes out
How to start
Too much ash
SMOKE setting
Clean the ash. Refer to MAINTENANCE
& CLEANING.
Start your grill on SMOKE setting with
thelid open, after 2 minutes, close the
lid and turn to any cooking setting
desired.
TROUBLESHOOTING
19
18