Instructions / Assembly

OPERAT
Each installation site for any unit presents its own unique combustion environment. Specific factors such as weather,
wind currents, yard debris, altitude, drafts, the size of the surrounding area, all have an influence on the proper
operation of the unit. A normally operating unit will demonstrate the following characteristics:
a) A lively, realistic yellow flame,
b) Odor-free.
• If the flame is not clean (identifiable by excessive sooting on the decorative media), refer to the CLEANING AND
MAINTENANCE section below.
A. Always shut off the gas to the unit while performing service work.
B. Allow the unit to cool before servicing.
C. The unit should be inspected regularly. Excessive debris can build up on this unit from leaves, dirt, or other debris.
It is critical that all control components, burners, and the surrounding area be kept clean and free of all
obstructions.
Keep the surrounding area at the base of the unit clean and free of obstructions at all times.
D. The burner assembly must be replaced prior to the unit being put into operation if it is evident that the burner is
damaged. Contact your local dealer for replacement parts.
E. Periodically perform visual checks of the burner flames. The burner flames
should be blue at the base with a combination of blue/yellow at the body and
tips .Contact a qualified service person for maintenance. Keep entire area (around bottom) clear for proper
venting
OPERATION
CLEANING &MAINTENANCE
CAUTION
HOT DURING OPERATION AND AFTER USE
Children must be supervised when in the vicinity of this appliance .Serious injury occur ! Children must be alerted to the hazard of
high surface temperatures and should stay away to avoid burns or clothing ignition