Instructions / Assembly

1. STOP! Read the safety information above.
2. Lay a lighted long-stem match on the surface of the
decorative media near the burner ring (do not hold the
match in your hand) (Fig.1) or use a lighted
long-necked butane lighter (Fig.2)
3. Push and slowly turn the control knob to the ON
position (see Fig.3). Your burner should light.
4. Observe the flame height when lit. Flame should
be 3 to 13 inches high (see Fig .4).
5. If the burner does not light before the match goes out,
immediately turn the control knob to the OFF position.
6. Wait approximately five (5) minutes to clear out any
gas, and repeat steps 1-4 above.
7. If your burner fails to light again, turn the control knob to
the OFF position and contact your dealer or gas supplier.
8. To extinguish your gas burner, turn the control knob to the
OFF position. Be sure the control knob is turned fully off to avoid any gas leakage.
MATCH LIGHTING INSTRUCTIONS
Fig.1
Apply match, then turn on gas
Fig.3
Fig.4
Pictorial representation of approximate flame height
Fig 2