Instructions / Assembly

1. STOP! Read the safety information above.
2. Push and slowly turn the control knob to the HIGH position
3. Hold the ignitor to light the burner， release control knob
after 45 seconds. See p1
4. Observe the flame height when lit. Flame should be
to 13 inches high .See P2
5. If 4.the burner does not light before the electron goes
out, immediately turn the control knob to the OFF position.
6. Wait approximately five minutes to clear out any gas
, and repeat steps 1-4 above.
7. If your burner fails to light again, turn the control knob to the
OFF position and contact your dealer or gas supplier.
8. To extinguish your gas burner, turn the control knob to the OFF
position. Be sure the control knob is turned fully off to avoid any
gas leakage.
OPERATING THE UNIT-LIGHTING AND EXTINGUISHING
ELECTRON LIGHTING INSTRUCTIONS
P2
P
ictorial representation of
approximate flame
P1