Instructions / Assembly

LOCATION
While following all requirements and safety information in this
manual; locate the unit on a flat, level surface.
CONNECT TO A PROPANE CYLINDER GAS SUPPLY
Important: Before installation, be sure the propane
cylinder is turned off.
Install the regulator hose assembly (not supplied) to the unit
using a gas pipe sealing compound or Te on Tape. Then
attach the regulator end to the propane cylinder and tighten
(see Fig.11-1). Follow all instructions and safety warnings
supplied with the propane cylinder.
Place the cylinder in the tank seat, and rotate the screw
clockwise to a fully stop. (see Fig.11- 2).
CONNECT TO A NATURAL OR HOUSEHOLD PROPANE
GAS SUPPLY
1. Connect a flex connector (not supplied) to the unit using
a gas pipe sealing compound or Teflon Tape (see Fig. 11-3).
2. Bring the gas-supply pipe up from beneath the unit near
its center.
Note: Locate the gas supply line out of pathways where
people may trip over it or in areas where the line may be
subject to accidental damage.
3. Install a flare adaptor (not supplied) to the gas supply
(NPT) using a gas pipe sealing compound or Teflon tape
(see Fig. 11-3).
4. Connect the flex connector to the flare adaptor (see Fig.11-3).
LEAK TEST
Turn on the gas supply, ignite the burner, and test at all
connections for leaks using a soapy water solution. If bubbles
appear, a leak is present. Turn off the gas and tighten at all
connections. Repeat until no leaks are present. If a leak
persists, turn off the gas supply and contact the local gas
company or dealer. NEVER USE A FLAME TO CHECK FOR LEAKS.
*The gas hose connector shall have a connector that complies with the Standard for Gas Hose Connectors
for Portable Outdoor Gas-Fired Appliances, ANSI Z21.54 CSA 8.4.
INSTALLATION (Cont.)
Fig.11-1 Propane cylinder
Fig 11-2
Fig.11-3