Installation Guide

6. Apply a dollop of silicon in the diameter of 2” at the center of the top metal
surface. Set the stone insert down leaving equal spacing between front to
back, side to side. Gently pressed down.
7. Leave it untouched for 12 hours for silicon/glue to set. Seal all stone
surfaces with stone sealer before use. Caulk along the sinks. Consult with
your local hardware store with regards to stone sealer.
Operation and Maintenance
1. All natural stones have pores on the surface and needs to be sealed before
contact with water. Especially those areas that will be in direct contact with
water i.e. stone inserts. It is highly suggested that you apply stone sealer as
needed to maintain its surface characters.
2. Avoid temperature cycle. Running extreme water temperatures within
short amount of time on natural stone can potentially damage the stone.
3. Avoid exerting excessive forces on the stone insert.
4. If water splash off from the insert to outside of the sink perimeter, adjust
water flow rates accordingly from the rough in valves.