User`s guide

NETWORK IP CAMERA User’s Guide

I. Reinstating the Factory Default Settings

This page explains instructions in detail on how to set the default settings in Network IP Camera. In

certain circumstances it may become necessary to restart or reinstate the Factory Default settings for

your Network IP Camera: This is performed by pressing the Reset Button, or using Hyper Terminal

Setting. Follow the instructions below to reinstate the product factory default settings

By pressing Reset button.

① Prepare clip or any sharp pin to press the reset button on the backside of Network IP Camera.

② Switch off the Network IP Camera by disconnecting the power cable.

③ Press and keep the Reset Button pressed, and then reconnect the power supply cable.

④ Keep the Reset Button pressed until the Operating Status LED (Green) blinks three times.

(Note that this may take up to 10~15 seconds), then release the button. When the Operating

Status LED (Green) blinks three times.

By Using Hyper Terminal

① Execute “Hyper Terminal” as

referred to Chapter “4.3.1

Configuring Hyper Terminal”

② Supply the power to the

Network IP Camera.

③ After a while, the count down

starts with the message

“Press 'p' key to stop auto-boot or

Load-Default-Button under the

NetCam for 3 seconds...”

.At this time, press ‘p’ key. Then,

[Network IP Camera Boot] prompt

shows like the right side image.

④ When you enter ‘w’, Administrator ID & Password reinstate as factory default ‘admin’

NOTE

Reinstating the original default settings will cause all parameters (Including IP address) to be

reset.