User`s guide

NETWORK IP CAMERA User’s Guide
37
② DNS Server
Set DNS Server Address of PC that Network IP Camera is connected. This address is required to email
to a specific users.
③ Server IP Address
Server IP Address is required to upgrade Network IP Camera Program. This Address must be same as
IP address of PC, which the upgrade program is executed. Refer to Chapter ‘E. Updating newly
updating Network IP Camera’s PROGRAM’
④ Web Server Port Number
To set Port Number for Web Server. (Default port number is ‘80’ and users can select from 80 to 1023)
⑤ Image Transfer Port Number
To set the port number for image transfer. (Default port number is “8000” and users can select from
8000 to 65535).
⑥ Upgrade port number
To set Port Number for upgrading firmware. Default port number is “9000” and users can select from
8000~65535. Be careful not to duplicate port number between Image Transfer Port Number and PTZ
port number. If it is duplicated, the warning message may appear (For more detail, refer to the
Appendix E. Updating Network IP Camera’s newly upgraded program).
⑦ PTZ port number
To set the port number for PTZ control. (Default is ‘10000’ and users can select from 8000 to 65535.
Be careful not to duplicate port number between Image Transfer Port Number and Upgrade port
number. If it is duplicated, the warning message may appear.
SUBMIT
Send configured data by user to Network IP Camera..
6.4 Admin, User Configuration
This page is to configure IDs and Passwords of an administrator and 5 users.