User`s guide

NETWORK IP CAMERA User’s Guide
36
① Set IP Address, Subnet mask, gateway address.
To set IP address, Subnet mask, gateway address manually, you may select “manually” in combo box.
In case of selecting “manually”, you can configure them by IP installer as well as this page.
(If you have trouble configuring network system information, please ask your network administrator.)
To set DHCP, you may select ‘using DHCP’.
In case of selecting “using DHCP”, IP address, Subnet mask address, Gateway address may not be
activated at all. Under DHCP selection, IP address may be sent to email address that is configured on
Event Trigger Page whenever IP address is changed.
Users in local network area may check IP address through IP installer.
NOTE
If you select “DHCP”, you may see the rebooting message “Now Network IP
Camera is rebooting to apply the changes...” on page. After completing
rebooting, Operating Status LED blinks once in every second. (The message may not be
changed at all. Therefore, you must check whether the Operating Status LED blinks.)
To select DHCP, you must have DHCP server in network area. Otherwise, IP address will
be rebooted automatically as the previous IP address. It may take 4 minutes for booting.
After rebooting, please reenter the previous IP address.
You may see the “fail” message from “Network Configuration” page.