User`s guide

NETWORK IP CAMERA User’s Guide
21
sequence. For more information on Network IP Camera upgrade, refer to “E. Updating Network IP
Camera’s Newly upgraded Program”.
Gateway inet (g) is the gateway address of Network Camera.
⑥ Type ‘c’ key to change the network configuration in [Network IP Camera Boot] prompt. If you
type ‘c’ key, Network IP Camera shows you the information you can change its values and the
current assigned values. You can change as the following figure.
⑦ When you terminate hyper-terminal program after you changed network configuration, hyper-
terminal program asks you whether you save the session. If you save the session, you can re-use
the hyper-terminal. To re-use the session you saved, click Start --> Programs --> Accessories -->
Communications --> HyperTerminal --> Network IP Camera.. ht in the case of Windows 2000.