User`s guide

NETWORK IP CAMERA User’s Guide

pressing ‘p’ key again.

Here, inet on ethernet (e), host inet (h) and gateway inet (g) values are network configuration values.

You should change these values in most case. If you don’t know what value you should assign, refer to

the network administrator.

Inet on ethernet (e) is IP address and subnet mask address of Network IP Camera. IP address and

subnet mask addresses are separated by colon (:). For example, IP address is represented by decimal

numbers delimited by dot (.) like ‘192.168.1.27’. Hexadecimal numbers like ‘ffffff00’ in the case of

‘255.255.255.0’ represents subnet mask address. Note that the numbers of subnet mask value are not

delimited by dot. See the example in the above picture.

Host inet (h) is the address to which Network IP Camera tries to connect to upgrade its firmware

program in flash memory. Network IP Camera first search this host on the network on booting