User`s guide

NETWORK IP CAMERA User’s Guide
19
4.3.2 Assigning IP Address
Follow the below steps to assign IP address by using Hyper Terminal
① Execute “Hyper Terminal” on your PC
② Connect RS232 Cable to the serial port of PC that you have selected in ‘4.3.1 Configuring Hyper
Terminal’ and Network IP Camera serial port while Hyper Terminal is executed.
③ Supply the power to Network IP Camera.
④ After a while, the count down starts with the message “Press 'p' key to stop auto-boot or Load-
Default-Button under the NetCam for 3 seconds...”
At this time, press ‘p’ key. Then, [Network IP Camera Boot] prompt shows like the below image.
⑤ You can see Network Configuration while [Network IP Camera Boot] Prompt is running by