User`s guide

NETWORK IP CAMERA User’s Guide
11
3 Installation summary, Connecting & Placing
3.1 Installation Summary
¾ Connect Ethernet and Power to Network IP Camera on local network for configurations
¾ Install a Installation program “IP-Installer” for Network IP Camera in to a PC on local network
¾ Assign an IP address to Network IP Camera and configure administrator’s conditions
¾ Place Network IP Camera for your purpose, and re-connect power and Ethernet
¾ Adjust the Focus
3.2 Connecting & Placing
¾ Connect Ethernet line to the Ethernet port in the rear of Network IP Camera
¾ Connect the power supply to a power supply port in the rear of Network IP Camera.
¾ Confirm that the power LED, Operating Status Indictor blinks.
¾ Place Network IP Camera appropriately for you purpose
WARNING
Network IP Camera is for indoor use. The built in CMOS (Complementary Metal Oxide
Semiconductor) can be damaged permanently if the camera lens is exposed to direct sunlight.
When Network IP Camera is placed under glaring light, and iris lens is recommended.
If your application demands prolonged exposure to sunlight, consider using a sun visor.