Technical information
Table Of Contents
- DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2
- 0TSAFETY AND PRECAUTIONS
- MAINTENANCE and CLEANING
- Daily Maintenance and Cleaning
- Weekly Maintenance and Cleaning
- Monthly or Periodic Maintenance
- Correcting a Bad Nozzle Check Condition
- Clear a Clogged Nozzle for the Print Head
- The Capping Station
- X & Y "0" Calibration Adjustment
- Print Head and Lamp Height Check
- Adjusting the head height
- Replacing a Direct Jet Print Head
- TROUBLE SHOOTING
- Error Conditions
- Hardware Troubleshooting Guide
- Print quality and Ink Supply Problems
- PRINTING - INFO SHEET AND FAQs
- DCS_Direct_Jet_UV_Printer_Maintenance_Log_REVB021413
Troubleshooting
Go to table of contents
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx 30 | Page
Hardware Troubleshooting Guide
Use the following table to indentify and fix Mechanical and Electrical faults
Symptoms Check Replace
The UV light is not lit.
The light will automatically shut off when the
temperature exceeds 104°F (40°C). It will turn
back on automatically when the operating
temperature has returned to an acceptable value.
The filter. If it is dirty, it will reduce air flow and
can cause high temperature leading to automatic
shut down.
The ambient temperature.
The filter
Switch AC main power on.
No lights on the control
panel and no table or
elevator movement when
control panel buttons are
pressed.
Check AC power cord.
Check AC power source (wall plug).
Check AC power fuses.
Replace power cord.
Change AC power
source.
Replace AC power fuses
Replace Printer Power
Supply