Technical information
Table Of Contents
- DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2
- 0TSAFETY AND PRECAUTIONS
- MAINTENANCE and CLEANING
- Daily Maintenance and Cleaning
- Weekly Maintenance and Cleaning
- Monthly or Periodic Maintenance
- Correcting a Bad Nozzle Check Condition
- Clear a Clogged Nozzle for the Print Head
- The Capping Station
- X & Y "0" Calibration Adjustment
- Print Head and Lamp Height Check
- Adjusting the head height
- Replacing a Direct Jet Print Head
- TROUBLE SHOOTING
- Error Conditions
- Hardware Troubleshooting Guide
- Print quality and Ink Supply Problems
- PRINTING - INFO SHEET AND FAQs
- DCS_Direct_Jet_UV_Printer_Maintenance_Log_REVB021413
Maintenance
Go to table of contents
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx 24 | Page
Check head height
Remove the tool. Press the down arrow button and hold it until the elevator stops, then
release it. This sets the print head height.
Using and the arrow buttons once again, move the table until it is under the print
head.
Slide the DCS Head Height Gauge between the Print Head and the Media Table. It should fit
all the way under the head, with very little gap (just enough to slide a piece of paper in
between. Move the head to another point on the axis and check again. Check in several
places. If there is any significant difference at any of these points, contact DCS Tech
Support for adjustment information. If the head height needs adjustment, go to page 25.
Otherwise, if the head is at the proper height, stack the two guides and check the height of
the UV lamp using the same method. If the lamp height needs adjustment, go to page 26.