Technical information

Maintenance
Go to table of contents
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx 22 | Page
Print Head and Lamp Height Check
When powering the printer back on, remember to turn on the main power then wait 5
seconds before powering up the print engine. This is to allow time for the LED light to
calibrate its distance from the print head.
Read all of the instructions prior to execution
T-15 Torx driver
Tools Required
.050" Hex Head Driver
3/32" Hex Head Driver
# 1 Philips head screwdriver (customer
supplied)
Head Height Gauge (.040" shim)
provided by DCS
PT-1320-T004 Head Height Tool
provided by DCS
Approximately 20 Minutes
Time Required
Make sure the print engine power is ON ( LED solid green).
Press and raise the print engine ½" so that there is no chance of damaging the print
head during this procedure. Press to move the table to print home. Open the Color
Byte Rip Pro Queue. Click OK on the Reminder dialog box that says "Have you performed
your weekly Ink Pad Reset?"
Select Queue from the toolbar; then select Manage Queues from the drop down menu.
Confirm that Epson Stylus
Photo R1900 (any USB
number is OK) is selected.
Click Close. Note, that any
time you connect a
different Direct Jet, you
will have to reselect this
printer option as each
board has its own unique
USB signature.
Click on the Printer Status and Settings icon.