Technical information
Table Of Contents
- DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2
- 0TSAFETY AND PRECAUTIONS
- MAINTENANCE and CLEANING
- Daily Maintenance and Cleaning
- Weekly Maintenance and Cleaning
- Monthly or Periodic Maintenance
- Correcting a Bad Nozzle Check Condition
- Clear a Clogged Nozzle for the Print Head
- The Capping Station
- X & Y "0" Calibration Adjustment
- Print Head and Lamp Height Check
- Adjusting the head height
- Replacing a Direct Jet Print Head
- TROUBLE SHOOTING
- Error Conditions
- Hardware Troubleshooting Guide
- Print quality and Ink Supply Problems
- PRINTING - INFO SHEET AND FAQs
- DCS_Direct_Jet_UV_Printer_Maintenance_Log_REVB021413
Maintenance
Go to table of contents
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx 19 | Page
X & Y "0" Calibration Adjustment
This procedure is used for adjusting the X and Y "0" point of the printer to be equal to the Color
Byte software "0" point.
1/16" hex head wrench
Tools Required
3/32" hex head wrench
Approximately 20 minutes
Time Required
1. Make sure the print engine power is ON ( the green LED is on solid).
2. Load a piece of 8.5" x 11" (or A4) paper or a white substrate of similar size. Use the edge
guides to align it on the left edge of the table.
3. Open the Color Byte Rip Pro Queue. Select the Color Only queue.
4. Be sure the table is at Print Home. Go to Devices>Print Test Page. Select the First Dot file and
click OK.
5. After the file has been imported, click Print.