Technical information
Table Of Contents
- DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2
- 0TSAFETY AND PRECAUTIONS
- MAINTENANCE and CLEANING
- Daily Maintenance and Cleaning
- Weekly Maintenance and Cleaning
- Monthly or Periodic Maintenance
- Correcting a Bad Nozzle Check Condition
- Clear a Clogged Nozzle for the Print Head
- The Capping Station
- X & Y "0" Calibration Adjustment
- Print Head and Lamp Height Check
- Adjusting the head height
- Replacing a Direct Jet Print Head
- TROUBLE SHOOTING
- Error Conditions
- Hardware Troubleshooting Guide
- Print quality and Ink Supply Problems
- PRINTING - INFO SHEET AND FAQs
- DCS_Direct_Jet_UV_Printer_Maintenance_Log_REVB021413
Maintenance
Go to table of contents
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx 18 | Page
4. Remove the locking bracket holding the unit
to the side plate. Use pliers to remove the
bracket from the side of the print engine.
Disconnect orange ground wire.
5. Disconnect the electrical cable that goes to the motor. Do
not leave the gender changer connected to the capping
station. Leave it connected to the wire that is attached
to the printer.
6. Carefully remove the unit.
7. Reverse procedure to install the replacement unit.
8. Select an Initial Charge from the Device Properties screen to get the ink flowing through the
new Capping Station.