Technical information
Table Of Contents
- DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2
- 0TSAFETY AND PRECAUTIONS
- MAINTENANCE and CLEANING
- Daily Maintenance and Cleaning
- Weekly Maintenance and Cleaning
- Monthly or Periodic Maintenance
- Correcting a Bad Nozzle Check Condition
- Clear a Clogged Nozzle for the Print Head
- The Capping Station
- X & Y "0" Calibration Adjustment
- Print Head and Lamp Height Check
- Adjusting the head height
- Replacing a Direct Jet Print Head
- TROUBLE SHOOTING
- Error Conditions
- Hardware Troubleshooting Guide
- Print quality and Ink Supply Problems
- PRINTING - INFO SHEET AND FAQs
- DCS_Direct_Jet_UV_Printer_Maintenance_Log_REVB021413
Maintenance
Go to table of contents
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx 16 | Page
The Capping Station
Clean the wiper blade
1. Press . Manually move the capping station away from the print head.
2. Pull back on the tab as shown below and
then flip up the wiper. Do not remove
the capping station. The picture is for
demonstration purposes only.
3. Wearing gloves, wipe the blade clean with an IPA wipe (provided in your cleaning kit). Inspect
the edge of the wiper blade for damage or irregular shaped dried ink that can't be removed
with cleaning. If it cannot be removed, the blade must be replaced. Contact DCS for
instructions for replacing the blade.
4. Return the blade to its original position.
5. Press the blue button again.
Wiper
Tab