Technical information
Table Of Contents
- DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2
- 0TSAFETY AND PRECAUTIONS
- MAINTENANCE and CLEANING
- Daily Maintenance and Cleaning
- Weekly Maintenance and Cleaning
- Monthly or Periodic Maintenance
- Correcting a Bad Nozzle Check Condition
- Clear a Clogged Nozzle for the Print Head
- The Capping Station
- X & Y "0" Calibration Adjustment
- Print Head and Lamp Height Check
- Adjusting the head height
- Replacing a Direct Jet Print Head
- TROUBLE SHOOTING
- Error Conditions
- Hardware Troubleshooting Guide
- Print quality and Ink Supply Problems
- PRINTING - INFO SHEET AND FAQs
- DCS_Direct_Jet_UV_Printer_Maintenance_Log_REVB021413
Maintenance
Go to table of contents
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx 14 | Page
3. Discard the old filter.
4. Clean the retainer and fan guard with a dry cloth if needed.
5. Place the new filter over the fan guard and secure with the retainer and 4 screws.
16. Replace syringes and filling needles every 28 days. No more than every 28 days,
discard all filling syringes and filling needles. Begin using new ones.
17. Clean encoder wheel for Y-axis every 84 days. Clean with an IPA wipe.
18. Every 3 months, replace the capping station. Go to page 16 for instructions.
19. Replace all ink cartridges every 84 days or more often as needed.
Fan guard
Retainer