Technical information

Maintenance
Go to table of contents
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx 11 | Page
Apply a drop or two of oil to the areas indicated. Do not over-lubricate.
The outside of
the print head
bushings on both
sides.
It is critical that the
area between the
print head bushings
be lubricated.
Apply the 3-in-1 oil and
then, using a gloved
finger, apply lithium
grease to the same
locations.
Upper and lower rail and
car on both sides of the
UV lamp carriage. Do
not use WD-40 on
the UV lamp rails.
Clean with an IPA
wipe when needed.
Manually move the print head left and right (do not move the lamp, it will follow
along with the print head) to spread the oil along the length of the shaft.
Again, using a gloved finger, apply a light grease (ex: lithium) in the areas indicated
to the print head upper guide.
Use a very small amount of
grease and apply to the
underside of the guide rail.
Apply in several areas, moving the print
head for access when necessary. DO NOT
grab the UV lamp. It will track with the
print head.
Move the print head left and right to ensure even distribution of the grease.