User Manual

4
HINGING THE ELEVATORS.
Aileron control horn : See below pictures.
HINGING THE RUDDER.
HINGING THE AILERONS.
AILERONS CONTROL HORN.
M3x40mm
2 sets.
Paste all hinges on the xed parts (wings,
tail).
Aer a reasonable period of time depend-
ing on the glue used permanently installed
mobile appendages ensuring that there is a
slight clearance for free movement of fric-
tion . During drying maneuver the pieces
to make sure everything runs smoothly. If
epoxy clean the excess glue with paper. Do
not use acetone.
Proceed as described at general, then check
the ns are aligned wingtip and move free.
See below pictures.
Proceed as described at general, then check
the edge ns are aligned and move free.
See below pictures.
Proceed as described at general, then check
the edge ns are aligned and move free.
See below pictures.
Hinge.