User Manual
3
To prevent damage to the coating cover
your workbench with a cloth or blanket.
Do not pull on the packaging you may be
too much pressure and break your plane.
Carefully unpack the wings and fuselage us-
ing scissors or a cra knife. Open aware of
hardware apart and sort all parts in order to
understand who goes where. Store in a se-
ries of independent small boxes. When you
work, do not let scews, miscellaneous hard-
ware, accessories and tools below dierent
parts of your aircra. Check constantly. Be-
fore gluing carefully prepare all the parts,
try them and if needed dig slots a bit more.
Work slowly and read many time techni-
cal instructions to be sure to understand all
tricks.Repeat gestures before using glue. If
overows do not use acetone on coatings
and plastics. Oen simply wipe with a paper
towel.
To ensure the mobility of aps we planned
cylindrical hinges. e trick is that these
hinges are installed at 90°mean 45°on each
side. See photos. at way when you leave
the aps deport these hinges and shutters
create a slot eect that brings the li in ad-
dition to limiting the braking eect of tur-
bulence aps and thus repel the stall speed.
All hinges are pre-installed but not glued.
Before removal for sizing carefully locate all
positions with a ballpoint pen not to create a
gap for the collage.Note the middle hinge so
that the same amount is depressed in both
parties. Plant may also serves as a needle
stop which provides the necessary play and
exibility. If you use the cyano coat once all
the hinges with a veil of cyano.
Drill your 45° holes about 2mm before the
edge. Be careful not to cross! Cut hinges
taking into account the thickness of the
wing. Introduce all hinges. e hinges must
be pressed closer, gently so that the oset is
reasonable. To check the alignment of the 3
hinges use simply your eye. If you need to
reduce the oset just push a bit more. Flaps
are manipulated to test the exibility of op-
eration. Monitoring the orientation of the
hinge pins to be perpendicular to the rota-
tional movement.
HINGING THE FLAPS.
INSTALLING HINGES GENERAL.
TIPS FOR ASSEMBLY