User Manual

1919
Epoxy
6) When you are sure that everything is
aligned correctly, mix up a generous amount
of 30 Minute Epoxy. Apply a thin layer to
the mounting slot in the top of the fuselage
and to the sides and bottom of the vertical
stabilizer mounting area. Apply epoxy to the
bottom and top edges of the ller block and
to the lower hinge also. Set the stabilizer in
place and realign. Double check all of your
measurements once more before the epoxy
cures. Hold the stabilizer in place with T-
pins or masking tape and remove any excess
epoxy using a paper towel and rubbing al-
cohol. Allow the epoxy to fully cure before
proceeding.
CONTROL HORN INSTALLATION.
1) Locate the nylon control horns- nylon
control horn backplates and machine screws.
2)e position of elevator control horn on
the le side of elevator. e clevis attach-
ment holes should be positioned over the
hinge line.
Control Horn.
Mounting Screws.
Mounting Plate.
3) Using a 2mm drill bit and the control
horns as a guide, drill the mounting holes
through the elevator halves.
4) Mount the control horns then into the
mounting backplates. Do not overtighten the
screws or the backplates may crush the wood.
5) Position the rudder control horn on the
le side of the airplane.
6) Install the rudder control horn using the
same method as with the elevator control
horns.
Elevator control horn.
Rudder control horn.
2x15mm
Hinge.
C/A glue.