User's Manual

QUICK START
1. Fully charge your Strack before
rst use.
2. Turn On your Strack by pressing
the power button.
3. Download the My Strack App
from Google Play or App Store
by scanning below code
4. Install the App, sign up with email.
5. Connect the Strack to your App.
6. Follow the instructions on the
App that will help you how to
use the Strack.
CUSTOMER SUPPORT
There are multiple ways you can
reach us
• Live Chat on My Strack App -> Go
to Menu -> Customer Support
• By Email– [e-mail]
• By Visiting at www.dipitr.com
• On What’s App + 91 9986088762
TURN ON/OFF STRACK
WEAR STRACK
Strack can be worn in two ways based
on user preference
1. Using Adhesive
Using Adhesive
• Peel off the sticker on device side of
the adhesive and stick it to the
back of the Strack
• Now peel the other side of the
adhesive & stick the Strack firmly
to your upper back, directly on your
spine
CALIBRATE STRACK
Calibration process helps your Strack
to decide your Straight Posture. It is
recommended to calibrate your Strack
every timeyou start your posture
detectionsessions. You can recalibrate
your Strack whenever you feel your
slouch posture is not properly
identified.
Calibration of the Strack can be
done in two ways
1. On Mobile App or
2. On Strack
On Mobile App
• Put the Strack on back as
suggested above
• To calibrate from the Mobile App,
connect your Strack to the Mobile
App
• Get in to your best(straight) posture
• Press Calibrate icon on the home
screen and stay still for few seconds
till your Strack vibrates three times
On Strack
• Put the Strack on back as suggested
above
• Get in to your best(straight) posture
• Put your left hand on the back and
double click the power button on
Strack
• Stay Still for few seconds till your
Strack vibrates three times
STRACK IN OFFLINE MODE
Strack can be used independently
without Mobile App. The three major
functions that are frequently used
are inbuilt in the Strack
Function 1 – Turn On/Off Strack
Function 2 – Vibration Alert On/Off.
Once Strack is turned On, the power
button works like a switch. You can
toggle vibration alert on/off by
pressing once
Function 3 – Calibration. Strack can
be calibrated without mobile app by
double clicking the power button.
2. Using Magnetic Clasp
LED INDICATIONS
Turn ON Strack Purple Blinks
Connected to
Mobile App
Green Blinks
Firmware Updating Solid Cyan
Turn OFF Strack Red Blink
Low Battery Red Blinks
Charging Red Blinks
Fully Charged Solid Green
STRACK USER MANUAL
MAGNET
Turn ON Strack
Press the button once to Turn on the
Strack
Turn OFF Strack
Press and Hold the power button
till the Strack vibrates and then
release the button to Turn Off
Using Magnet
• Place the Strack beneath your
clothing just above the spine on
your back
• Attach the Magnetic Clasp from top
of your clothing
SPECIFICATIONS
Name - Strack 360° Posture Care Device
-Net Weight
-Battery Capacity
- Lithium polymer batteryBattery Type
- Bluetooth Wireless Connectivity
4.2 BLE
– Biocompatible Skin Friendly Material
High Grade Polycarbonate
– 33 MM * 47 MM * 9 MMDimensions
– Android & iOS OS Support
For Warranty info please visit
www.dipitr.com/strackwarranty
Need help ?
Call us on 9986088762
OR
Visit www.dipitr.com
OR
Scan QR code to get information
on How Strack Works
VIBRATION ALERTS
SWITCH FUNCTIONS
Turn ON Strack 1 Short Vibration
Turn ON Strack
Vibration
Enable/Disable
Press and Hold
the Switch
Turn OFF Strack
Calibration
Success
3 Short Vibrations
Low Battery 2 Long Vibrations
Turn OFF Strack 2 Short Vibrations
Vibration Enable 1 Short Vibration
Press the Switch
once
Press the Switch
twice
Calibrate Strack
Press the Switch
once
REGULATORY & SAFETY NOTICES
USA: Federal Communications Commission
(FCC)statement
This device complies with FCC part 15 FCC
Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful inter-
ference
2. This device must accept any interference,
including interference that may cause
undesired operation of the device.
FCC WARNING
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.
FCC STATEMENT:
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reaso-
nable protection against harmful interfere-
nce in a residential installation. This equip-
ment generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no gua-
rantee that interference will not occur in a
particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be deter-
mined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help. This device
meets the FCC and IC requirements for
RF exposure in public or uncontrolled
environments
European Union (EU)
Simplified EU Declaration of Conformity
Hereby, Dipitr Technologies, Inc. declares
that the radio equipment type Model
FB401 is in compliance with Directive
2014/53/EU.
Déclaration UE de conformité simplifiée
Dipitr Technologies Inc. déclare par la
présente que les modèles d’appareils
radio FB401 sont conformes à la Directive
2014/53/UE.
Dichiarazione di conformità UE semplificata
Dipitr Technologies, Inc. dichiara che il tipo
di apparecchiatura radio Modello Fb401
è conforme alla Direttiva 2014/53/UE.
Vereinfachte EU-Konformitätserklärung
Dipitr Technologies, Inc. erklärt hiermit,
dass die Funkgerät Typen Modell Fb401
die Richtlinie 2014/53/EU erfüllen.
Declaración UE de Conformidad simplifi-
cada Por la presente,
Dipitr Technologies, Inc. declara que el tipo
de dispositivo de radio Modelo FB401
cumple con la Directiva 2014/53/UE.
Disposal and Recycling Information
The symbol above indicates that this prod
uct and/or battery should not be disposed
of with household waste. When you decide
to dispose of this product and/or its battery,
do so in accordance with local environme-
ntal laws and guidelines.
Built-in battery precautions
• Do not attempt to replace your Stracks’
battery. It is built-in and not changeable.
• Charge the battery in accordance with the
instructions supplied with this guide.
• Charge your Strack using a certified
computer, powered hub or power supply
• Do not attempt to force open the built-in
battery