Users Manual
Please do not measure immediately after intense exercise, or immediately
after exposure to strong sunlight or sweating.
Please make sure the measuring area (inner wrist) is not covered by clothes,
jewelry or watch etc., for an accurate reading.
6. Specification
Thermometer Chips Melexis thermopile temperature measurement
Thermometer Distance 3 5cm-
Temperature Correction Self-calibration
Disinfectant Mode Infrared sensor probe
Power Supply DC 12V 2A /
Thermometer Accuracy ± . ℃(±32.54
℉)
0 3
Recognition Speed <3S
Store Environment
Working Environment
Store Temperature
Working Environment
Hardware
Indoor (avoid direct sunlight)
Temperature: 0℃-35℃（32℉-95℉)
Humidity: 10%-90%(No condensation)
Among 25℃(77℉) （No condensation)
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should
be installed and operated with a minimum distance of 20cm(7.9 inches) between the
radiator and your body for 2.4GHz operations: Use only the supplied antenna.