Instruction Manual

31
2
3. Install restraint as shown in appropriate installation
sections (see pages 14 to 24 for restraint installation
instructions).
4. After installing restraint, pull top tether adjuster strap
to remove all slack.
Tether Connecting Strap
WARNING:
Tether connecting strap is ONLY to be used in rear facing
installations.
With some vehicle models, the top tether may not t
structural parts of vehicle seat or there may not be a
suitable anchorage point for top tether hook. It may be
necessary to use the tether connecting strap to create a
tether anchorage point:
1. Locate attachment point where a vehicle seat belt is
anchored directly to frame of vehicle, OR nd the leg of
a vehicle seat that is bolted to vehicle frame.
2. Wrap tether connecting
strap around vehicle leg
or seat belt anchorage
point, and thread metal
‘D’ ring through the loop
at end of tether connect-
ing strap. Pull strap to
form a tight knot. (Fig. 3)
3. Now, use metal ‘D’ ring as an anchorage point for top
tether metal hook.
3