Instruction Manual

20
WARNING:
• Remove detachable base when restraint is
forward-facing.
• Do NOT place infant in forward-facing restraint until 1
year and 20 lbs.
• ALWAYS use SafeStop installation for forward-facing
child below 40 lbs. (See page 28).
• Do not install with this method for a child weighing more
than 40 lbs.
• See page 42 for LATCH connector instructions.
Fig. 1 shows a typical forward-facing installation with
LATCH.
Stability of installation can
be improved by using top
tether shown in blue, Fig. 1
(see page 30 for top tether
instructions).
1. Conrm vehicle seating
location has its own LATCH
anchors. If it does not, you
must use vehicle seat belt
installation
(see pages 22 and 24).
2. Locate LATCH belting secured in storage compartment
on restraint back. Press red release button to remove
each LATCH connector and webbing. Slide the narrow
LATCH tethering strap out of plastic strap guides on
side of the seat.
3. Place restraint in forward-facing position: Lower the
adjustable bottom (see page 29) for child over 25lbs,
but do not for child under
25lbs. Place restraint bottom
at on vehicle seat and slide
back until top of restraint
rmly contacts vehicle seat
back.
4. Route LATCH belt through
forward-facing belt path and
behind restraint cover.
(Fig. 2)
Forward-Facing LATCH Installation
1
2
2