Instruction Manual
15
2
3
4
5. Route LATCH belt through
rear-facing belt path.
Conrm LATCH belt lays at
and is not twisted. Attach
each connector to the
LATCH anchor closest to
each side of the restraint.
(Figs. 2 & 3)
LATCH connector will ‘click’
to conrm attachment to
anchor.
6. Push restraint down rmly
into vehicle seat while
tightening LATCH belt.
(Fig. 4)
Vehicle cushions should
compress where there is
contact with restraint.
CHECK LIST:
Conrm restraint is properly positioned.
Conrm LATCH belt is tight and that connections to
approved LATCH anchors are secure.
Conrm restraint installation is stable (see page 25).
Stability of installation can be improved by using top
tether (see page 30 for tether instructions).
Removal:
• Press red release button on each LATCH connector to
release it.
• Disconnect top tether if in use.
• Properly store LATCH belt and top tether.