User manual

Fixing to a wall
1) Mark off the position using the bracket as a guide.
2) Drill two fixing holes for each bracket, taking into account the length of
cable from the solar panel and light fitting.
3) Secure the brackets to the wall.
4) Mount the solar panel onto its fixing bracket (which should be above the
light fitting), and set it to the appropriate angle and tighten.
5) Plug the solar panel into the socket on the light fitting.
6) Install the battery, this slides onto the back of the light fitting (take care
handling the lithium battery).
7) Fit the weather protection case cover.
8) Mount the light fitting onto its fixing bracket and set to the optimum
position for detection.
9) You can test that the system is working by covering the solar panel, the
light fitting should now illuminate.
Fixing to a 50mm pipe
1) Attach the ‘U’ brackets, the light fitting and solar panel bracket to the pipe
using the nuts and bolts provided. Take into account the length of the
connection cable.
2) Mount the solar panel onto its fixing bracket (which should be above the
light fitting), and set it to the appropriate angle and tighten.
3) Plug the solar panel into the socket on the light fitting.
4) Install the battery, this slides onto the back of the light fitting (take care
handling the lithium battery).
5) Fit the weather protection case cover.
6) Mount the light fitting onto its fixing bracket and set to the optimum
position for detection.
7) Point the PIR in the area you wish to detect.
8) Test the PIR by walking in front of the unit with the solar panel covered.
5