User manual

SET UP GUIDE

NOTE: Theunit will not operate correctlyunlessit is fully charged.When

charging the Diodor LED Solar Floodlight, the chargeLEDshouldflash

RED. If LED is flashing orange, this indicates a battery fault or the

battery may not be connecetd correctly. Remove the battery, clean the

contactswith a non-metalliccloth and carefullyslidethebattery backon.

1) Unpackand checkthe contentsin the box, andcheckto makesureyou

havethecorrecttools for installaiton. (Seepage9-10for kit contents).

2) Removelithium batteryfrom the packaging,takingcarewhenhandlni g.

Carefully slidelithiumbatteryontothebackof thelight fitting,andtheunit

is nowreadyto charge.

3) To charge the unit, plug the solarpanelandlight fitting together. Once

exposedto sunlight,theredchargeLEDshouldflashto indicatetheunit is

nowcharging.

4) We suggest you charge the battery beforeinstallation, in direct sunlight

for at least5 hours. Keepout of reachof children.Oncefully charged

removethebattery(placesomewheer safe) anddisconnectthesolarpanel.

5) Finda suitable location to install your new Diodor LED Solar light

fitting,(Seepage7 for choosinga location).

6) Mount the solarpanelandlight fitting to thewalleitherwith wallbrackets,

or ‘U’ bracketsto 50mmpipe,takinginto accountthelengthof thecables.

7) Align the solarpanelfacingthe sun at around10 o’clock for optimum

charging and thentightenthesolarpanelto thebracketaccordingly.

8) Carefullyslidethebatteryonto thebackof thelight fitting andensureit is

fully lockedin place.At this point do not plug the solar panelto the light

fitting. Pleasetakecarenot to touchthemetal connectionson thebottom

thebattery.