Instruction Manual

Page 3 of 3
Please ensure a compable MLV dimmer switch and dimmable LED xture is installed. Incompable dimmer switches and/or xtures are the most
common triggers for faulty installaons.
• Lights are ickering: An incompable dimmer switch or defecve driver may produce excess strobing/ickering. Ensure a compable dimmer is
installed. See dimmer switch specs for minimum load requirements. If excess strobing/ickering is sll apparent, please contact technical support.
• Reset breaker trips repeatedly: Ensure the driver is not overloaded. Always de-rate the driver 20% it’s labeled rang. Ensure there is not a short
circuit occurring. If the breaker connues to trip aer reset then contact technical support as the driver may be defecve.
• Excess voltage drop: Ensure applicable AWG wire is installed between driver and xture. Addionally, an MLV dimmer switch will trim voltage down,
causing an output less than 12VDC or 24VDC. Performance will not be aected if the xture is receiving ≥ 10.5VDC (12V models) or ≥ 21VDC (24V
models). Use the Orange Boost Tap (see ‘Boost Tap’) as an oponal voltage boost in place of the Black (Line) wire if the xture is receiving noceable
light degradaon (200W & 300W models only). Cap the exisng hot wire not in use.
Troubleshoong
For addional quesons/concerns please contact technical support. We are more than happy to assist you with any technical dicules or concerns.
MAGNETIC DIMMABLE DRIVER
INSTALLATION GUIDE
V2.1